JA-80Z Wireless Repeater Unit

JA-80Z Wireless Repeater Unit

The JA-80Z signal repeater can extend the range of remote devices whose signal is not strong enough to communicate with the control panel or whose communication is unreliable.

More details

Not in stock - estimated delivery is in 2 to 3 weeks

JA-80Z Wireless Repeater Unit

The JA-80Z signal repeater can extend the range of remote devices whose signal is not strong enough to communicate with the control panel or whose communication is unreliable.

The repeater function lies in the retransmission of a signal received from an enrolled device with a little delay. The delay ensures that a possible conflict between the repeater transmission and the transmitting device is avoided. Each device enrolled to the repeater must concurrently be enrolled to the control panel

  • The repeater has 40 addresses for devices and one address for an OASiS control panel
  • It copies the state of the PGX, PGY, IW and EW outputs of an OASiS control panel.
  • The addresses are filled by sequential enrollment. The enrolled devices can only be deleted by resetting the repeater.
  • Uses an LED and beeper (if connected – just for installing and testing purposes) to indicate the strength of the signal received from enrolled devices.
  • Compatible with all OASiS detectors and remote controls with the exception of the JA-84P.
  • It does not support transmissions for JA-8xF keypads, JA-80A sirens and other JA-80Z repeaters.
  • Enables a hard-wired detector connection to the INP terminal.

double-balanced INP input with a selectable natural reaction (default: delayed loop) is available for the connection of one hard-wire detector. Activation of this input is transmitted to the control panel as a signal from a device to which the repeater has been enrolled in the control panel. The reaction of this loop can be configured in the control panel.

The repeater front cover is protected with a built-in tamper sensor and the box must be protected against being torn off the wall with a tamper device delivered with the package.

The repeater must be equipped with a backup battery (e.g. SA-214/1,3) which ensures its operation when there is a power supply failure

 

Specifications

Power source

230 V / 50 Hz, max 0.1 A, protection class II

Power supply

type A (EN 50131-6)

Backup battery

12 V, 2.2 Ah

Backup power output

maximum continuous load 0.7 A

Number of wireless device addresses

40

Hard-wired inputs

1x double balanced input (one input reserved for the rear tamper contact)

EW external warning output

switching to GND, max. 0.5A

IW internal warning output

switching to GND, max. 0.5A

PGX, PGY outputs

max. 0.1 A, switching to GND

Frequency (JA-82R)

868 MHz

Security grade

2 (according to EN50131-1, EN 50131-6 and EN 50131-5-3)

Environmental class

II. indoor-general (-10 to +40°C) compliant with EN 50131-1

Radio emissions

ETSI EN 300220

EMC

EN 50130-4, EN 55022

Safety

EN 60950-1

Can be operated according to

ERC REC 70-03

Maybe you like